Join our Community in its new Home - The Datorama Trailblazer Community Group!
It's been an amazing 3 years coming together in this forum to collaborate, innovate, support, and inspire each other about our shared usage of Datorama. While this is not quite a goodbye, we are excited to announce that we are getting a fresh start in our new home within the Salesforce Trailblazer Community. We have a ton of fun new content planned and you may even see the revival of some of our most popular posts from the past few years.
We’ll be keeping this group around for a bit for you to peruse, but as of November 15, we will no longer be allowing new posts or comments. Be sure to join our new group at https://www.salesforce.com/success-datorama to keep the conversation going.
We can’t wait to see you there!
It's been an amazing 3 years coming together in this forum to collaborate, innovate, support, and inspire each other about our shared usage of Datorama. While this is not quite a goodbye, we are excited to announce that we are getting a fresh start in our new home within the Salesforce Trailblazer Community. We have a ton of fun new content planned and you may even see the revival of some of our most popular posts from the past few years.
We’ll be keeping this group around for a bit for you to peruse, but as of November 15, we will no longer be allowing new posts or comments. Be sure to join our new group at https://www.salesforce.com/success-datorama to keep the conversation going.
We can’t wait to see you there!
How to map Calculated Dimensions.
Meiling
Boston, USAACCOUNT_ADMIN 
in Help Center
Hi,
i'm very new here, wanted to know how to map calculated dimensions into an existing data stream. It shows up in the pivot table but I cannot see it to map a different field based on the new calculated formula.
Thanks in advance. Any help would be appreciated.
i'm very new here, wanted to know how to map calculated dimensions into an existing data stream. It shows up in the pivot table but I cannot see it to map a different field based on the new calculated formula.
Thanks in advance. Any help would be appreciated.
Tagged:
Comments
Calculated Dimensions are different than the mapping fields in a Data stream. Thus, you can't reference a Calculated dimension in the mapping.
Here are two Knowledge Base articles you can refer to:
Calculated dimensions
Mapping
If you provide some additional info on your exact use-case and end goal, I can advise you on how to approach it in the most suitable way
Best regards,
Tsvete