Join our Community in its new Home - The Datorama Trailblazer Community Group!
It's been an amazing 3 years coming together in this forum to collaborate, innovate, support, and inspire each other about our shared usage of Datorama. While this is not quite a goodbye, we are excited to announce that we are getting a fresh start in our new home within the Salesforce Trailblazer Community. We have a ton of fun new content planned and you may even see the revival of some of our most popular posts from the past few years.
We’ll be keeping this group around for a bit for you to peruse, but as of November 15, we will no longer be allowing new posts or comments. Be sure to join our new group at https://www.salesforce.com/success-datorama to keep the conversation going.
We can’t wait to see you there!
It's been an amazing 3 years coming together in this forum to collaborate, innovate, support, and inspire each other about our shared usage of Datorama. While this is not quite a goodbye, we are excited to announce that we are getting a fresh start in our new home within the Salesforce Trailblazer Community. We have a ton of fun new content planned and you may even see the revival of some of our most popular posts from the past few years.
We’ll be keeping this group around for a bit for you to peruse, but as of November 15, we will no longer be allowing new posts or comments. Be sure to join our new group at https://www.salesforce.com/success-datorama to keep the conversation going.
We can’t wait to see you there!
calculating dimensions using EXTRACT
Jacob
ACCOUNT_ADMIN 
I have created a formula to pull a new dimension from a column in my data stream titled "Campaign". It is in the 9th position of the nomenclature. However, when I test my formula I receive an "unbalanced braces" error.
IF(EXTRACT(csv['Campaign'],_,8)="rmktg","Remarketing",
IF(EXTRACT(csv['Campaign'],_,8)="pros","Prospecting",
"other"))
Tagged:
Comments
I think that is due to the "=" you used in the syntax should be "==" instead.
For the formula operator you can use, please see this Support Article in our Knowledge Base.
Hope this is what you are after.
Venus